How to Install a Garage Keypad: Quick & Secure Guide
Enhance your garage security with a simple keypad installation!
Introduction
A garage door keypad is a great way to get in and out easily.
It’s safe and works at the push of some buttons.
You won’t need your keys anymore!
Credit: store.geniecompany.com
Tools and Materials Needed
Before you start, gather these items:
- Garage door keypad
- Drill with screwdriver bits
- Two mounting screws (usually included)
- Phillips head screwdriver
- Wireless keypad (if wireless)
- Batteries (if required)
- Level
Choosing the Right Location
First, pick the best spot for your keypad.
It should be:
- Within reach, about chest high
- Close to the door for easy access
- Away from moving parts of the door
Installation Steps
Step 1: Mount The Keypad
Place the keypad against the wall.
Use a level to make it straight.
Mark the screw holes with a pencil.
Step 2: Drill Pilot Holes
Use the drill to make starter holes.
They should be smaller than your screws.
This makes it easier to screw them in.
Step 3: Attach The Keypad
Line up the keypad with the holes.
Screw in the mounting screws.
Don’t make them too tight yet.
Step 4: Program The Keypad
Follow the manual to set your code.
Every keypad is a little different.
Make sure to remember your new code!
Step 5: Test The Keypad
Try the new code a few times.
Make sure the door opens and closes.
If it works, tighten the screws.
Step 6: Cover And Finish
Put any covers on the keypad.
Clean up your work area.
Your new keypad is ready!
Credit: www.youtube.com
Troubleshooting Tips
If your keypad doesn’t work, try these:
- Check the batteries if it’s wireless
- Make sure the code is correct
- Look for obstructions near the door
- Reset the keypad following the manual
Conclusion
Installing a garage keypad is easy.
It makes getting into your garage simple.
You’ve just made your home safer!
Garage Door Technician
